Home > SCSI2SD >

SCSI2SD v5 with extended Molex power whip

Price: $59.99



SCSI2SD emulates a SCSI-I or SCSI-2 hard drive using a micro-SD memory card. Each SCSI2SD purchase includes a fully assembled and tested circuit board, ready for use.

SCSI2SD v5 is an and open source project. Please visit the SCSI2SD page at http://www.codesrc.com/mediawiki/index.php?title=SCSI2SD, where you will find the GPL3+ software source code.

Note: The hardware design for SCSI2SD v5 not currently open source, unlike version 4.


  1. Built-in active terminator.
  2. Emulates up to 4 SCSI devices simultaneously
  3. Supports sector sizes from 64 bytes to 8192 bytes
  4. Firmware updatable over USB
  5. Highly configurable over USB
    • Selectable SCSI ID
    • Selectable parity support
    • Enable/disable Unit Attention Condition
    • Artificial limits on the SCSI disk size (eg. limit size to 4G to avoid OS bugs)
    • Sector size (can also be set via the SCSI MODE SELECT command, as sent by SCSI format utilities).
  6. External LED connector.

Technical Specifications

SCSI InterfaceSCSI-2 Narrow 8-bit 50-pin connector. Supports asynchronous transfers only.
SD Card InterfaceStandard SDSC (1GB maximum size)

SDHC, SDXC (up to 200GB)


5V via standard molex drive connector, USB, or SCSI BUS powered (requires the SCSI host to supply terminator power)

Dimensions10cm x 5cm x 2cm


Please consult the full compatibilty list at http://www.codesrc.com/mediawiki/index.php?title=SCSI2SD